Free USA
HPI Slide Carb w/Pull Start G3.0 [101310]

Slide Carb w/Pull Start G3.0

101310  

HPI Racing 

New  

$114.29

Sign in or create an account to earn 11 loyalty points with each purchase of this product!

Last items in stock! (1 available)

This is the Nitro Star G3.0 Engine with Pullstarter supplied with the
HPI Bullet ST 3.0 Monster Truck and Bullet ST 3.0 Stadium Truck

Features:

  • ABC liner construction, "A"luminum piston with "B"rass cylinder
  • Liner that is "C"hrome plated
  • Two needle composite body slide valve carburetor
  • SG type (integrated pilot shaft) crankshaft
  • Two year limited warranty through HPI beginning at date of purchase

In the Package:

  • Nitro Star G3.0 Engine with Pullstarter, Air Filter Assembly, Glow
  • Plug, and Instructions

Specifications:

  • Displacement: .18 cu in (3.0 cc)
  • Output not provided by manufacturer
  • Distance between Mounting Holes Same Side: 0.47" (12mm)
  • Distance between Mounting Holes Opposite Side: 1.2" (31.5mm)
  • Height from Mounting Tab/top of Cylinder Head: 3" (76mm)
  • Height from Bottom of Crankcase/top of Cylinder Head: 3.5" (89mm)
  • Width of Mounting Tabs: 1.6" (40mm)
  • Length from Pull Starter to Front Bearing: 3" (75.5mm)
  • Length from Back Plate to Front Bearing: 2.2" (55.5mm)
  • Length from Pull Starter to end of Crankshaft: 4.2" (107mm)
  • Length from Back Plate to end of Crankshaft: 3.5" (88mm)
  • Carburetor Settings;
  • High Speed Needle: 1/4-3/4 turn clockwise from flush (never turn
  • Past a maximum of 3/4 turn clockwise from flush)
  • Idle Adjustment Screw: Turn counterclockwise to reduce idle speed
  • Or clockwise to increase, idle speed should not engage clutch,
  • Set throttle trim on radio to neutral before setting idle
  • Low Speed Needle: Set flush with carb body, let engine idle for 30
  • Seconds, then accelerate to 3/4 throttle. If there is a lot of
  • White smoke and slow acceleration the mixture is too rich. If car
  • Accelerates quickly and sputters, the mixture is too lean. Turn
  • Needle in 1/8 turn increments to adjust. Do not turn past 2 turns
  • From flush

Requirements:

  • Glow Fuel: Car blend nitromethane with 20-25% nitro content
  • Glow starter, air filter oil and track equipment

No reviews at this time.

 

Write a review


*



Only registered users can report abuse.

Log in or create an account .
Only registered users can vote for a review.

Log in or create an account .