Castle CC CapPack [011-0002-02]

CC CapPack

011-0002-02  

Castle Creations 

New  

$22.24

Sign in or create an account to earn 2 loyalty points with each purchase of this product!

CC CapPack


CC CapPack is useful in all brushless motor
applications, where it serves to give just that little boost needed to
overcome ripples in the battery voltage caused by hard acceleration or
long battery wires. Remember, ripple voltage is hard on an ESC, adding
the CC CapPack can help reduce the load on the controller's on-board
capacitors
Helis: CC
CapPack is highly recommended for all 500 class and larger heli
applications where Y harnesses and long wires can bleed voltage and hard
collective pulls can strain even the most powerful batteries

Cars/Trucks: With their
high torque requirements going from 0 to 100% throttle isn't easy on
controllers or batteries - RC cars and trucks put enormous loads on
brushless power systems. Use CC CapPack to help your system power
through the abuse

Aircraft: Larger
electric power systems lead to larger electric powered aircraft, and
sometimes the distance between the battery pack and the ESC grows beyond
the length of the wires installed on the components. Adding wire also
adds inductance, which can increase the ripple voltage in a system. CC
CapPack essentially negates the ripple caused by the addition of up to 8
inches of length to the battery wires
CC CapPack is designed for quick and easy installation
Users simply cut the soft silicone insulation on the battery wires do
this as close to the ESC as possible and place the exposed wires in
the channels on CC CapPack's posts. Check for proper polarity and then
solder the wires to the posts. Use the included heat shrink to finish
it off for a professional looking install

Specifications:

  • Length: 1.8 (45.7mm)
  • Width: 0.78 (19.8mm)
  • Height: 0.7 (17.6mm)

Comments:

  • All Castle controllers with data logging capabilities can
  • Report the ripple voltage they encounter during use. Ripple voltage
  • Peaks should always be less than 10% of the total pack voltage; the
  • Smaller the ripple voltage the better. If an application exhibits more
  • Than 10% ripple voltage under peak loads, the user should consider using
  • Higher discharge (C Rating) batteries, shorter wires, higher current
  • Connectors, better gearing or a smaller load
  • Multiple CapPacks may be used in an application. They should all be installed as close to the ESC as possible

No reviews at this time.

 

Write a review


*



Only registered users can report abuse.

Log in or create an account .
Only registered users can vote for a review.

Log in or create an account .